Hi
I need your advice and would welcome help on where to connect incoming and outgoing supply to a Tend TEW16 DOL Motor Starter for my 2.5HP single phase woodsaw motor.
I have checked previous advice on this forum and elsewhere but am still not certain.
My google research "seems" to tell me that incoming & outgoing feed should connect to:
L1-Live
L2-Neutral
(other advise tells me Neutral to L3 and / or 13NO)
Supply to motor should be:
T1-Live
T3-Neutral
(other advise tells me Neutral to 14NO)
I attach 2 x pics which I hope will help.
Also if the pictures are not clear I give the following info' about the motor starter terminals.
L1 is strapped to A1 being immediately above/below each other.
L3 is strapped to 13NO.
13NO is also connected to green "ON" button.
A2 immediately below 13NO has an unused wire from it. (another terminal A2 is immediately below 14NO)
a terminal on the green "ON" button is strapped to a terminal on the red "OFF" button and a lead from that terminal connects to 14NO.
The second terminal on the "OFF" button has an unused wire from it.
I hope I haven't bogged you down with to much information.