Hi there,
First time poster, so please be kind. The problem is that after flushing my toilet , it does not stop filling, so it runs. This is then where it gets strange. If you run the bathroom sink tap on full (located next to the toilet) the toilet stops running immediately. Then when you next flush, the process starts again. Also, the float valve does detect that the water level should stop, as the arm and float move to stop it. But the water keeps running.
I need to know whether this is perhaps a water pressure problem (I.e. Too much), or whether my toilet float valve is faulty. Or maybe just a simple washer problem. Or something else?
A bit of info: the toilet is less than two years old. The problem has been happening for about 6 months (I've now decided that enough is enough). I have already adjusted the float so that it is supposed to stop at a lower water level.
Many thanks
Phil.