Ask The Trades | |
https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl
DIY Forum >> Plumbing Questions >> Cutting Speedfit/Hep2 pipe??? https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl?num=1102785627 Message started by nyck on Dec 11th, 2004, 5:20pm |
Title: Cutting Speedfit/Hep2 pipe??? Post by nyck on Dec 11th, 2004, 5:20pm What the best option for cutting the pipe.I've only need to cut a few bit so didn't want to splash out £12-15 for the cutters. The guy in the plumbers shop said just use cutting wheel as used for the copper pipe. any advise welcome nyck |
Title: pRe: Cutting Speedfit/Hep2 pipe??? Post by thescruff on Dec 11th, 2004, 5:47pm a sharp pair of secateurs would do scruff |
Title: Re: Cutting Speedfit/Hep2 pipe??? Post by JerryD on Dec 11th, 2004, 10:35pm I wouldn't use pipe slice (cutting wheel) as the rollers may damage the smooth face of the pipe. This smooth face is essential to make a watertight seal with the O ring. A new Stanley blade should be ok if you don't have sharp secateurs. The cut needs to be pretty square but doesn't have to be perfect. I bought the proper cutting tool for about £7 I seem to remember. |
Title: Re: Cutting Speedfit/Hep2 pipe??? Post by HandyMac on Dec 12th, 2004, 12:22pm Might be worth checking ebay for something like a vinyl pipe cutter. HM |
Title: Re: Cutting Speedfit/Hep2 pipe??? Post by nyck on Dec 13th, 2004, 8:15am I tried the cutting wheel which worked OK(Make the tool is clean) I then used a old pair of secateurs which were brillant No leaks sor far thanks for the Advise nyck |
Ask The Trades » Powered by YaBB 2.3! YaBB © 2000-2008. All Rights Reserved. |