Ask The Trades | |
https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl
DIY Forum >> Plumbing Questions >> Mixer Tap https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl?num=1263842257 Message started by Lectrician on Jan 18th, 2010, 7:17pm |
Title: Mixer Tap Post by Lectrician on Jan 18th, 2010, 7:17pm My dads mixer tap (monoblock) is weeping slightly when turned on from where the top swivel part meets the lower fixed part. There is a screw on the lower fixed part. If you release this screw, I am assuming there is then a washer of some sort I can replace? Anything to look out for? |
Title: Re: Mixer Tap Post by woodsmith on Jan 18th, 2010, 8:07pm Often a series of rubber O rings, but the plumbers might know better ;) |
Title: Re: Mixer Tap Post by Joiner on Jan 18th, 2010, 8:13pm Err. There's no hope for any of us when the bloody forum admin gets the threads mixed up. ;D ;D ;D You won't live that down for a while Lec. ::) |
Title: Mixer Tap Post by Lectrician on Jan 18th, 2010, 9:46pm This Topic was moved here from DIY Carpentry Questions by Lectrician. Not quote sure how that happened! ::) |
Title: Re: Mixer Tap Post by TIMBA-WOLF on Jan 18th, 2010, 11:07pm Wrong thread/section... Bet thats left him (cable) REELING!!!!! (check out the avatar) and as for the tap, as WS states normally a large-ish "O" ring seal... common fault/problem........ |
Title: Re: Mixer Tap Post by thescruff on Jan 19th, 2010, 4:08am Yes undo the screw and it should pull out. 1 or 2 O ring washers. |
Ask The Trades » Powered by YaBB 2.3! YaBB © 2000-2008. All Rights Reserved. |