Ask The Trades - Print Page

Ask The Trades
https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl DIY Forum >> Alarms, Phones, Aerials, CCTV & Datacomms >> Ports Module - BT Versatility https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl?num=1366305867 Message started by gurk on Apr 18^th, 2013, 6:24pm

Title: Ports Module - BT Versatility
Post by gurk on Apr 18^th, 2013, 6:24pm

Hi,

I've just installed a Ports Module into a Versatility system, but the new extensions don't appear to be working, they're not appearing in the handset menus and are greyed out in the Versatility Wizard software.

It's hard to tell whether the Ports Module is actually working as it has no LEDs to indicate whether it's receiving power or not.

Am I missing something obvious?

Title: Re: Ports Module - BT Versatility
Post by davie on Apr 22^nd, 2013, 8:13am

Can,t you tap over the ports with your butt , & see if there is any DT /Data ? My guess is that the vers isn't seeing the module.The connector isn't that great . Take the module off , then re-install it

Title: Re: Ports Module - BT Versatility
Post by gurk on Jul 1^st, 2013, 11:31pm

Got the extensions working, thanks!

After tapping the ports I noticed the main CCU wasn't sitting in its correct position, it had slid to left so the backplane wasn't properly connected.