Ask The Trades | |
https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl
DIY Forum >> Electrical Questions >> extend a power cable https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl?num=1511286757 Message started by MikeW on Nov 21st, 2017, 5:52pm |
Title: extend a power cable Post by MikeW on Nov 21st, 2017, 5:52pm Simple question really....& yes, I will try to find a reasonable sparks to help out when we figure out the best route! We have a big new projector screen to use with a new projector. The projector is "ultra short throw", which means it sits on a table 40cm from the wall and throws a 100" display - very impressive! The electric screen, however, arrived with about a 5' lead. Not even long enough to reach the floor :( Don't really want to have it dangling to an extension cord (as we have at the moment!) - would like to route it either round the ceiling and down the corner, or round a door frame behind the screen when down. Question is this: to avoid a lumpy extension plug, & therefore to be able to hide the power in a 16mm duct box, what is the best/safest/easiest (perm any 2 from 3 perhaps!!) way to extend the cable? I read about cutting & soldering, also 'butt connector' crimps, as well as spliceline connectors. In the distant past I have used 'choc blox' connectors to good effect, but I am sure there are neater/safer/tidier ways. Welcome the thoughts. In Leicester area in case there are trades here who can offer to help (at a cost!) - new to the forum so maybe that is not allowed! |
Title: Re: extend a power cable Post by Lectrician on Nov 21st, 2017, 8:36pm Replacing the flex would be preferred. Or, even better, a ceiling mounted socket and Fused Spur Outlet. |
Title: Re: extend a power cable Post by Natedog on Nov 23rd, 2017, 9:24am Is the flex permenantly attached or.does it plug I with a kettle lead type connector? If it plugs in then that would be the easiest solution, long leads are easy to get |
Ask The Trades » Powered by YaBB 2.3! YaBB © 2000-2008. All Rights Reserved. |