Ask The Trades | |
https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl
DIY Forum >> Building Questions >> Attic conversion https://www.askthetrades.co.uk/cgi-bin/yabb/YaBB.pl?num=1512074982 Message started by JohnOmcc1983 on Nov 30th, 2017, 8:49pm |
Title: Attic conversion Post by JohnOmcc1983 on Nov 30th, 2017, 8:49pm Hi. I am thinking about converting my aticket into a bedroom. The roof has a support beam running along it. I am the middle house in a bank of 3 houses. The beam is actually 2 beams that run from the houses either side of me and join in the middle of my attic. Picture attached I have a couple of queries - how could this beam be replacedar by a metal beam, without taking the whole roof off? - could the angled support bit of wood be safely removed? May be replaced with a vertical one or as it resting on a load bearing wall, could I build the wall up to support the beam? - I was thinking about an extension on one side of the roof. Taking the slant away and squaring it up. Do you have a rough estimate on how much it would cost? Thanks in advance John [gallery]JohnOmcc1983/1512074295.jpg[/gallery] |
Title: Re: Attic conversion Post by woodsmith on Dec 1st, 2017, 12:19pm You could engage a structural engineer to look at this or, perhaps better still, find a specialist loft converter who should be able to answer your questions. The support beam is called a purlin and you definitely can't remove the brace or replace it with a vertical one without an engineer's report and building consent. As for building a brick wall underneath to support it, or swapping it for steel, whilst it may be possible to do this you would again need a structural engineer's report and building consent. As for pricing it's impossible to say but loft conversions normally start at about £25,000 for a small basic bedroom addition and go upwards from £35,000 for bedroom and bathroom. |
Title: Re: Attic conversion Post by thescruff on Dec 1st, 2017, 4:33pm That age/build of roof/loft probably only has 3x2 ceiling joists and not load bearing |
Ask The Trades » Powered by YaBB 2.3! YaBB © 2000-2008. All Rights Reserved. |