Welcome, Guest. Please Login or Register
Welcome To Ask The Trades!
Jun 10th, 2026, 5:01pm
Quote: They didn't know it was impossible, so they did it - Mark Twain


Ask The Trades › DIY Forum › Plumbing Questions › Kingfisher 2 Boiler and Hot Water
(Moderator: thescruff) - (Moderator Group: Board Moderator) < Previous Topic | Next Topic >
Page Index Toggle Pages: 1
Send Topic Print
Kingfisher 2 Boiler and Hot Water (Read 1445 times)
fredthetread
GDPR opt-out
Kingfisher 2 Boiler and Hot Water
Jun 26th, 2007, 10:31am  
Hi - I apologise now if this seems like a stupid question

I have got a Kingfisher 2 Boiler and it is currently only used for central heating.

I want to know if I can use this for heating my water as well as currently I am using an immersion heater.

The controller I have does not have seperate programs for heating and water it is just one set of programs.  It is made by Danfoss

Can this be done or is it a case of new boiler etc.

Thanks
Back to top
 
 
IP Logged
 
chtechie
GDPR opt-out
Re: Kingfisher 2 Boiler and Hot Water
Reply #1 - Jun 26th, 2007, 10:38pm  
Your info is a bit sketchy but I think I've seen your arrangement before - If you could post photos of the programmer & your HW cylinder that would help. The most likely bits you will need are a 3 port valve, tank stat, new programmer & either a new HW cylinder or a conversion kit (if they're still available) to make it an indirect cylinder. There'll also be some piping changes & some new electric cables.
Back to top
 
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Print
(Moderator: thescruff) - (Moderator Group: Board Moderator) < Previous Topic | Next Topic >
Ask The Trades › DIY Forum › Plumbing Questions › Kingfisher 2 Boiler and Hot Water

Ask The Trades » Powered by YaBB 2.3!
YaBB © 2000-2008. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge