jasonB
GDPR opt-out
|
I thought that I may have problems with this pump install.
It is in a flat, the CW tank is directly above the HW cylinder, level of water in tank 7FT top of cylinder 4FT approx. Supplies from tank 28mm & 28mm until reduced to each outlet. Elbow out of top of cyl, 300mm of horizontal pipe then Tee, up to vent down to pump.
Fitted a whole house pump which is sucking in air through the vent. There is very little room between the top of the cyl and tank base so would an essex flange be the way to go?
Not fitted one of these before, anything to look out for, the cyl is approx 25yrs old.
Thanks, Jason
|