greg
GDPR opt-out
|
I had to hang a couple of doors for a mate, 2' 6" the linings were installed by someone else, not 100% plumb but not too bad, have seen worse. Both linings measured 30" across + / - a small amount
Q is. Whats the general view on butt hinges, should they always be let into the door and lining?
On the two i did, one i let the hinges into the door but if i let them into the lining aswell then the gap would not have been equal all the way round, the other one i let the hinge into the door and also had to let the lower hinge into the lining but not the upper.
I know that this could be down to linings not being 100% true, but to be honest it looked as though if they were completely true then it would have meant that both would have needed letting in on the door but not the linings.
Whats your views
Cheers
|