Ask The Trades - veritas R8

Welcome, Guest. Please Login or Register

	Apr 29^th, 2024, 10:39pm
View recently thanked users View top thanked users

Quote: The problem with the gene pool is that there is no lifeguard.

Ask The Trades › DIY Forum › Alarms, Phones, Aerials, CCTV & Datacomms › veritas R8

(Moderator: Lectrician) - (Moderator Group: Board Moderator)

< Previous Topic | Next Topic >

Pages: 1

veritas R8 (Read 3514 times)

paulpa

GDPR opt-out

veritas R8
Jul 11^th, 2012, 9:02pm

Even though i have set Full Set entry Time (sec) to 30 it only gives me about 3-5 seconds before sounding alarm.
Conducted walk test and opening closing door activates the zone ok.
In the texacom R8 installation manual i can't see any other timer.........

Could it be i have to walk passed a PIR to get to keypad and that is setting it off?

EDIT: Now set the PIR i walk passed to inhibit entry rather than guard and works ok.
What exactly is the difference between inhibit entry and guard?

Also would like advice on how i set the system for part set, i.e have downstairs PIRs and door contacts active at night

IP Logged

Lectrician Administrator Trade Member Author Offline Ask The Trades Posts: 8814 Total Thanks: 109 For This Post: 0 Braunton, North Devon United Kingdom Gender: Trade: Electrician	Re: veritas R8 Reply #1 - Jul 12^th, 2012, 7:08am Inhibited entry is what you need to set any PIR to that is on the entry route. This should only really be the hall detector. Any other detector should really be positioned to avoid this. Any zone set to inhibited entry will respond as normal (guard) when the system is set, but will be ignored during the entry timer period.
Back to top	Need to post a picture? Click HERE for info! IP Logged

paulpa GDPR opt-out Total Thanks: 109 For This Post: 0	Re: veritas R8 Reply #2 - Jul 12^th, 2012, 8:00am Thanks
Back to top	IP Logged

Franco

GDPR opt-out

Total Thanks: 109
For This Post: 0

Re: veritas R8
Reply #3 - Jan 26^th, 2013, 3:05pm

Hi I'm trying to set this alarm system to delay when I go downstairs in the morning after part setting it during the night (at the moment the sensor triggers alarm as soon as I get close to the bottom of the stairs).

Any ideas how I would go about this please? Didn't set the system up so appreciate if any thoughts can be a little bit idiot proofed

IP Logged

Lectrician Administrator Trade Member Author Offline Ask The Trades Posts: 8814 Total Thanks: 109 For This Post: 0 Braunton, North Devon United Kingdom Gender: Trade: Electrician	Re: veritas R8 Reply #4 - Jan 26^th, 2013, 5:21pm Do you know the engineer code? Can you obtain it from whoever set it up? Without this, you cannot easily make the changes. A full reset would be required to default the engineer code, and then the whole system re-programming.
Back to top	Need to post a picture? Click HERE for info! IP Logged

Pages: 1

(Moderator: Lectrician) - (Moderator Group: Board Moderator)

< Previous Topic | Next Topic >

Ask The Trades › DIY Forum › Alarms, Phones, Aerials, CCTV & Datacomms › veritas R8